Monument Plastic Pipe Cutter

I was devastated when losing the cutters nothing compares to them and they do not fail to cut any waste, we have even managed to cut 2" when in a tight position.

I did a video review about these cutters a while ago....
But wey hey they are superb. can cut all plactice pipes including solvent weld upto 43mm and they cut with ease.
Have to clamp the pipe & pull them back but then the rachet takes over & makes it so easy.
Can't do without them.

Sold cutter leaves a perfect cut every Time works really well ok 32/42mm pipe and as well as the smaller pipes 10/15/22/28
And again really well built for the cost.

Fantastic cutters, nice and sharp cuts through pipe like a knife through butter and leaves a perfectly smooth edge. Much faster than my ratchet cutters and the build quality is unmistakably Monument ⭐️⭐️⭐️⭐️⭐️

Great tool wouldn’t be without it! Got two of these now they are excellent on wast pipe nice clean cut, well made and replacement blades can be purchased if like me you stuff one up!

I’ve had numerous pairs of these over the years I was found to be well built and easy to use and good value for money
My go to tool for cutting plastic
( I’m not too bad for cutting leadpipe )

Nowhere near as good as the rothenberger equivalent. Squashes 15 & 22mm, struggles to cut 32 and 42 in tight spaces. Definitely not worth the money

These larger plastic pipe cutters are really good for 1 1/4 pipe and 1 1/2 pipe for basin and kitchen waste. Nice easy cuts and nice straight cuts every time

Purchased one of these at short notice for a job that had quite a few cuts when installing 25mm cable trunking, build quality and ease of use is good and obviously will also cut the smaller 20mm conduit as well, but in fairness there are cheaper cutters available that also cut larger diameter water waste pipes which i also undertake so really only now used for the electrical side of my business.

Fantastic plastic pipe cutters, easy and smooth operation, stay sharp for a long time if you only cut plastic pipe with them, these are a standard in mt tool kit. Nice and lightweight, Nice and cheap too.

My reviews reflects the fact that they should be bigger. I use the cutter that do waste pipe as well as plastic.

I've been using these pipe cutters for a long time now, I used to use a hacksaw but got fed up deburring them, the time this tool had saved me messing about is amazing, wouldn't be without own now. I've had the same one for years and the blade is still cutting really well, money well spent

Recently got these instead of speedfit cutter so far so good but need a bit more testing from me

Not very impressed to be honest. Recently upgraded as my speedfit cutter which i had for over ten years had finally gone blint. This is pretty blunt after only a few times of use

Great quality use on a daily basis thrown about all over site blade sharp as it was the day I bought it.

Cuts well in general

Great for plastic pipe, just remember to twist as you cut !

Found it often cracks the pipe